• Based on a classic distortion circuit famous by indie pedal phenom, bass dirt guru, and Fuzzrocious Pedals founder Ryan Ratajskifor
• Dry, Wet, Tone, Distortion, & LED / SIL switch controls
• Dry : Controls level of direct signal
• Wet : Controls level of effect signal
• Tone : Shapes tone of distortion signal
• Distortion : Controls amount of distortion
• LED/SIL Switch : Toggles from silicon to LED clipping (indicated by blue LED)
• LED GAIN knob (internal) : sets max output of LED mode

• Thick, powerful distortion with superior definition
• Heavy, aggressive, and razor-sharp tone but remains  tight and focused
• Features custom Dimebag graphics
• Gain, Output, Bass, Mid, Treb & Scoop switch controls
• Gain : Controls amount of distortion
• Output : Controls overall effect volume
• Bass : Cuts or boosts low frequencies
• Mid : Cuts or boosts midrange frequencies
• Treb : Cuts or boosts high frequencies
• Scoop switch : Cuts midrange at 1kHz by -22dB (indicated by yellow LED)
• Powered by included 18V adaptor or any 18v power supply

• Provides the perfect balance of wah control and pedalboard-efficiency.
• 4 popular sweep ranges to choose from, allowing change of tonal character
• Q control shapes the wah’s response, from a narrow bandpass that emphasizes higher end harmonics to a wide bandpass that emphasizes lower end harmonics.
• Handy LED indicate when it’s active.

• Pedalboard friendly,small, lightweight housing that's built like a tank
• 10 outputs is fully isolated, eliminating gig-ending ground loop noise
• Features power on/off and connection status LEDs.
• 2x 9V @ 100mA 
• 2x 9V @ 300mA
• 2x 9V @ 450mA
• 2x 18V @ 250mA 
• 2x 6V - 15V @ 250mA
• The two 6V - 15V variable outputs can be used to emulate voltage "sag" - a drained battery effect sought by many vintage tonechasers
• Comes with 10x DC Cables
• 18v Adapter included : ECB009 18-volt adapter
• Please read through description for full info on this power supply features

• Delivers clean, steady voltages to a diverse range of pedal types in a sleek form factor so that you can confidently power your entire board without any extra bulk
• Fully isolated outputs to preserve signal purity and cut out environmental noise
• Features power on/off and connection status LEDs
• 2x 9V DC @ 500mA (fixed) 
• 4x 9V DC @ 300mA (fixed) 
• 2x 9/12/18V @ 500mA (switchable)
• 1x 9V DC output @ 1.5A (for high-demand multi-effects units such as the Line 6 HX Effects processor and HX Stomp amp/processor)
• 1x 18V DC output @ 2.0A (to link / connect a secondary power source such as the MXR Iso-Brick Power Supply or the MXR Iso-Brick Mini Power Supply)
• Compact, slim & lightweight design, perfectly sized to fit under most Pedaltrain pedalboards
• Comes with 10x DC Cables, all the mounting brackets and screws, & IEC cable
• Dimensions : 235 (W) x 88 (D) x 37 (H) mm / 9-1/4 (W) x 3-7/16 (D) x 1-7/16 (H) inches
• Weight : 0.84 kg / 1.9 lbs.

• Rich, creamy, overdriven tube sound
• Thickens up lead tones with musical, amp-like distortion and sustain without the fragility and inconsistency associated with tubes
• Op-amp gain stage into a FET stage
• Level, Drive, Hi, Lo, & Hi Cut controls
• Output : Set your volume level
• Drive : Dial in the grit, from subtle soft-clipping to early stage distortion
• Hi and Lo : Boost / cut the FET Driver's sound
• Hi Cut switch : To roll off high end frequencies when playing in high volume situations

• Designed in conjunction with the legendary Slayer guitarist.
• Create scooped-mid rhythm tones.
• Dual outputs.
• Adapter 18V included: Yes

• Tuned to a lower frequency and featuring a custom-wound resonance inductor, this wah has a huge dynamic range and a wide sweep
• Heavy duty die-cast casing featuring custom Slash artwork and a distressed hot-rod paintjob
• Blue LEDs on both side’s of the pedal indicate ON/OFF status

• Analog envelope filter
• True Bypass
• 9-volt operation or optional power supply

• Combines La Machine Fuzz with old school Sub Octave signal
• Octave Up mode for searing fuzz
• Toggle between Series/Parallel modes

• Swiss Army knife of wah pedals
• Features a six-position Range Selector control allows you to choose from six different frequency ranges, each position based on the unique tonal characteristics
• Variable Q control allows you to take the 535Q’s response from narrow and sharp to broad and subtle
• Features an adjustable / switchable boost, that can create endless sustain (up to +18dB)

• Rich, warm bucket-bridgade delay
• Up to 600ms of delay time and modulation
• Delay, Mix, Regen controls & Mod switch 
• Mod switch : Toggles modulation on/off (blue LED indicates on)
• Mix : Controls blend of wet and dry signals
• Regen : Sets number of repeats
• Delay : Sets delay time
• 2x internal trim pots : Adjustable width & rate control of the modulation

• Smooth vintage delay tones and tape-based echo with 20ms to 300ms of delay time
• Delay, Feedback & Blend controls
• Delay : Adjusts warm organic delay times between 20ms and 300ms
• Feedback : Sets the number of echo repeats
• Blend : Regulates ratio of dry to delayed signal

FEATURES

• New Signature Octave / Fuzz Pedal for Slash
• Limited Availability
• Both Octave Up & Octave Down
• Killer Fuzz Tones


•  

• Special "Bright" Edition
• Classic Carbon Copy tone but tuned to have brighter sound
• Repeats have more defined with a distinct vocal quality.
• Up to 600ms of delay time and modulation
• Delay, Mix, Regen controls & Mod switch 
• Mod switch : Toggles modulation on/off (blue LED indicates on)
• Mix : Controls blend of wet and dry signals
• Regen : Sets number of repeats
• Delay : Sets delay time
• 2x internal trim pots : Adjustable width & rate control of the modulation

• Both Clean and Distortion channels.
• Run direct to the PA or straight to the mixing board.
• Smart “noise gate” and optimized EQ.